A note from the owner and C.E.O of Show Gear International, Brett J. Partica:
"After breaking my back as a touring set carpenter-setting up and striking barricade every day for months on end- I knew there must be a better way to get the job done without putting the burden onto me and my crew. I also knew that with a few base design changes, the load in and load out of barricade could be done much easier and more efficiently. These simple changes would save the user both time and energy. The end result of these changes is the SGI Pro Series Super Duty Barricade System. Made specifically for ease of use, crowd safety and uncompromising strength and durability.”
High tinsel strength, lightweight aluminum alloy.
All sections initially snap into place with spring helio pins.
No hardware needed on level surfaces. Industry standard 5/16” coffin locks join sections.
Standard nut and bolt hardware receivers in place on all sections to utilize standard bolting if desired.
Our Pro Series® Barricade has only 1 corner type (45) to make inventory and planning simple and efficient. The Pro Series® 45 corner is reversible to inside outside. Our 2-45-piece (90) corner eliminates “true 90” crowd pinch points to increase safety.
The Pro Series® cart system “clam shells” open for efficient loading and unloading. There is no longer any need for your crew to reach in and over cart structures. Our carts are also collapsible and stackable when empty, allowing you increased on site storage during events.
Setup and strike can be achieved with just 2 persons.
Timed setup and take down speeds average 15 seconds per section.Check out our wholesale “factory to floor” pricing below!